Black Glossy Mug
• 11oz mug dimensions: height - 3.85" (9.8 cm), diameter - 3.35" (8.5 cm)
• 15oz mug dimensions: height - 4.7" (12 cm), diameter 3.35" (8.5 cm)
• Glossy finish
• Microwave and dishwasher safe
Important: This product is available in US only. If your shipping address is outside this region, please choose a different product.
Looking to Calibrate you resin? Check out our tutorial on calibrating your resin / printer combo with our 3DRS Starship Calibration Test - Click Here
|General printer Settings||
Small - Medium Build
|Bottom Exposure Time||35-45||35-45||35-45|
|Bottom Light-Off Delay||1||1||0|
|Bottom Lift Distance||12||8||8|
|Bottom Lift Speed||40||65||65|
General Post-Print Procedures
We recommend post cleaning your prints using clean, high purity 99% IPA (Isopropyl Alcohol). For Best results, utilize Vortex mixers or Ultrasonic Cleaners to quickly remove excess resin for a maximum of 10-15 minutes. Avoid leaving prints to soak for extended periods. See Table A for general absorption rates. (Always wear safety glasses and protective gloves when handling 3D Printing Resin).
Completely dry your piece before post curing. Be sure all sides of your print receive equal light exposure to avoid unequal shrinkage on the overexposed side. Unequal cure can damage or dis-form your print. For best results, post cure your print until the surface tack is removed - Extended cure times can increase tensile strength which may be ideal for hollowed prints. When the material is properly post cured, All sides of your print should have equal color and your piece should be noticeably harder.
Table A: Percent weight gain before post curing "Green Solvent Resistance". 1x1x1 cm cubes printed with Table A settings on Creality LD-002R then immersed in respective solvent for 15 minutes. The lower the absorption rate, the less likely the print will experience surface deformations.
|IPA 99%||0 - .82 %|
|Acetone (not recommended)||3.2 %|
Please do not hesitate to Contact Us with any questions or comments you may have. If you have the perfect settings on a specific printer you would like us to add, we welcome your input.