3DRS Studio Grey
3DRS Studio is a rapid printing, rigid-tough, precision engineering resin designed for both large and small format printing and fabrication.
functional parts, Fabrication / Cosplay, Snap-fits, Fixtures, Tooling, casings, general engineering resin
Mono Settings: 2.5-3.5s @ 50um - 4.5-5.5 @ 100um
|Notched Izod Impact Testing||35 j/m2|
|Tensile Strength||6,300 - 7,000 (psi)|
|Elastic Modulus||267,000 - 280,830 (psi)|
|Elongation at break||7-10%|
|UV Peak Absorption||405nm|
We worked closely with Corrison Studios here in Chicago to develop a resin to suit their production and design requirements. As many companies do, Corrison Studios spent time creating a complex blend of multiple resins from multiple companies to create a custom mix that would work for their needs - they came to 3DRS in hopes of finding a solution - 3DRS Studio Resin was the outcome and we now make that same formulation available to you.
FREE Shipping on domestic resin orders.
NOTE: the final products printed with the our U.V Resins are not intended or acceptable for direct food contact and are not safe to place in the mouth, even when properly dried and cured. Do not print products for any person or pet who may chew on or otherwise orally ingest the product.
Download Safety Data Sheet Here
Store & Usage:
1.Store in cool dry places between 18-28C
2. Avoid any direct sunlight during usage.
3. Shake well before use.
4. After printing, please wash your print in alcohol with the content of above 90
5. Use at temperature 18-28C
Looking to Calibrate you resin? Check out our tutorial on calibrating your resin / printer combo with our 3DRS Starship Calibration Test - Click Here
|General printer Settings||
Small - Medium Build
|Bottom Exposure Time||35-45||35-45||35-45|
|Bottom Light-Off Delay||1||1||0|
|Bottom Lift Distance||12||8||8|
|Bottom Lift Speed||40||65||65|
General Post-Print Procedures
We recommend post cleaning your prints using clean, high purity 99% IPA (Isopropyl Alcohol). For Best results, utilize Vortex mixers or Ultrasonic Cleaners to quickly remove excess resin for a maximum of 10-15 minutes. Avoid leaving prints to soak for extended periods. See Table A for general absorption rates. (Always wear safety glasses and protective gloves when handling 3D Printing Resin).
Completely dry your piece before post curing. Be sure all sides of your print receive equal light exposure to avoid unequal shrinkage on the overexposed side. Unequal cure can damage or dis-form your print. For best results, post cure your print until the surface tack is removed - Extended cure times can increase tensile strength which may be ideal for hollowed prints. When the material is properly post cured, All sides of your print should have equal color and your piece should be noticeably harder.
Table A: Percent weight gain before post curing "Green Solvent Resistance". 1x1x1 cm cubes printed with Table A settings on Creality LD-002R then immersed in respective solvent for 15 minutes. The lower the absorption rate, the less likely the print will experience surface deformations.
|IPA 99%||0 - .82 %|
|Acetone (not recommended)||3.2 %|
Please do not hesitate to Contact Us with any questions or comments you may have. If you have the perfect settings on a specific printer you would like us to add, we welcome your input.