What is MUD? (READ BEFORE ORDERING)

This batch of MUD was tested on the MONO X 4k at 2.5s normal exposure and passed our 3DRS Starship Calibration Test. 

3DRS MUD will be available from time to time (Subscribe to our newsletter to be notified when a new batch becomes available).

We fully test for functionality before selling. 

This is a bargain! MUD is high quality 3D Printing Resin available to you at a fraction of the cost. Available while supplies last.

In Short, 3DRS MUD is combined leftover material and/or material that is out of spec for it's brand designation. All Colors, all resin systems, mixed together and tested for functionality. With each batch of 3D Resin manufactured here at 3DRS comes a small amount of leftover material.  This is unavoidable and over time this really adds up!  Typically, this material would become waste. Instead, we decided to combine these leftover materials together and offer the result to reduce waste. whatever we get, we get. Each and every batch will be different so do not expect to get the same product twice. 

There are no warranties expressed or implied. All sales are final.

FREE Shipping on domestic U.S.A. resin orders 

NOTE: the final products printed with U.V Resins are not intended or acceptable for direct food contact and are not safe to place in the mouth, even when properly dried and cured. Do not print products for any person or pet who may chew on or otherwise orally ingest the product.

Download Safety Data Sheet Here

Credit to designer: The model featured in the product image was designed by Artisan Guild. 

Store & Usage:
1.Store in a cool DARK place between 18-28C - Keep container away from light exposure during storage to avoid light contamination. 
2. Avoid any direct sunlight during usage. 
3. Shake well before use.
4. After printing, post wash your print in IPA alcohol with the content of above 90 Or HERO WASH
5. Use at temperature 18-28C

Looking to Calibrate you resin? Check out our tutorial on calibrating your resin / printer combo with our 3DRS Starship Calibration Test - Click Here

Below is a quick overview, download a more complete excel spreadsheet of resin settings here. 

General Post-Print Procedures 

We recommend post cleaning your prints using clean, high purity 99% IPA (Isopropyl Alcohol). For Best results, utilize Vortex mixers or Ultrasonic Cleaners to quickly remove excess resin for a maximum of 10-15 minutes. Avoid leaving prints to soak for extended periods. See Table A for general absorption rates. (Always wear safety glasses and protective gloves when handling 3D Printing Resin).

Completely dry your piece before post curing. Be sure all sides of your print receive equal light exposure to avoid unequal shrinkage on the overexposed side. Unequal cure can damage or dis-form your print. For best results, post cure your print until the surface tack is removed - Extended cure times can increase tensile strength which may be ideal for hollowed prints. When the material is properly post cured, All sides of your print should have equal color and your piece should be noticeably harder.

Table A: Percent weight gain before post curing "Green Solvent Resistance". 1x1x1 cm cubes printed with Table A settings on Creality LD-002R then immersed in respective solvent for 15 minutes. The lower the absorption rate, the less likely the print will experience surface deformations. 

Please do not hesitate to Contact Us with any questions or comments you may have. If you have the perfect settings on a specific printer you would like us to add, we welcome your input.